Lets Build a Fireplace Mantel, Paint Grade

Double Taper Sanding Disc: https://www.mikefarrington.com/dt-disc

In this video I build, paint and install a fireplace mantel. I show my various methods for building the structure. Then I dig deep into how I cut and install the various moldings, and I give a behind the scenes look at my spray finishing process. I also show a few of my favorite router bits and where I use them. Hopefully you enjoy the video.

Tip Jar... Patreon: https://www.patreon.com/MikeFarrington

Affiliate links. Using these links to purchase tools helps support this channel.
4" double square: https://lddy.no/nei1
Clamps I like, these fit in a dovetail slot or a 20mm dog hole: https://lddy.no/neht
My favorite all around table saw blade: https://lddy.no/olxq
I like this flip stop, I use it on my miter saw and table saw sled: http://lddy.no/oly0
Marking gauge: https://lddy.no/oly5

Air filter for spray gun: https://amzn.to/3lvUQKP
Replacement cartridge: https://amzn.to/32HmblS
Newer version of my spray gun: https://amzn.to/3ly7V6q
Pressure cup for spray gun: https://amzn.to/36vUPjL
Cabinet Coat paint: https://amzn.to/3f99jdn
Paint strainers: https://amzn.to/35sbC7L

Flush trim v groove router bit: https://amzn.to/2Up5hUt
Mini round over: https://amzn.to/32F56ck
Ogee for underside of top: https://amzn.to/3no6I20
Jig saw: https://amzn.to/32GBew5
Pin nailer: https://amzn.to/3lvEAt5
Miter clamps: https://amzn.to/3f1jFf1
Track saw: https://amzn.to/2YBDwdO
Biscuit joiner: https://amzn.to/34EwPvx
No 0 biscuits: https://amzn.to/3pvhwxg
No 20 biscuits, small pack: https://amzn.to/2Iy6Ixa
Drill and impact driver: https://amzn.to/32ufEdb
Glue: https://amzn.to/32AS5zo